Order Today:
1-877-816-8714

Assembly and Set Up

POWER TOWER

ASSEMBLY:  The Power Tower is assembled except that the top part needs to be bolted to the bottom.  The bolts required are in one of the buckets.  Lift the top of the Tower Straight up and slide the top onto the bottom.  When the bolts are properly secured the Power Tower is ready to be positioned on the deck and the mounting anchors installed. 

DANGER:  DO NOT USE THE POWER TOWER

UNTIL IT IS SECURED TO THE DECK

The Power Tower must be secured to the deck before use.  We have included stainless steel anchor kits, filler set screws and nylon screws for that purpose. 

The anchors are about 1 1/4" long and 1/2" in diameter.  Place the Power Tower on the deck in the lane where it will be used and mark the locations of the holes drilled into the rear cross members of the Power Tower.   They are on each end on the side of the Tower on which the wheels are mounted.  If drilling into tile, mark the spot with a center punch to prevent the drill bit from "skating" from the correct spot.  Start with a small bit and expand the hole to 1/2" in dimaeter and the exact depth of the anchor.  Place the ancour and use the installation tool to drive the anchor into the hole.  The tool will force expansion of the bottom of the anchor and will secure it in place.  The Tower may now be secured using the nlyon screws included.  When not in use the anchors may be capped off with the stainless steel set screws included. 

For further instruction call

1-877-816-8714